FAQ

This content will be replaced when pagination inits.

1. State the difference between first and third angle projection?
2. How to create a template in CAD software?
3. Define CAD
4. State the use of configuration in Solid works?
5. Define the purpose of design table in Solid works?
6. How to create bill of materials?
7. Define fit and tolerance.
8. What are the rules of GD&T?
9. Define Poisson's ratio.
10. Define Young's Modulus and Bulk modulus.
11. Define fatigue strength
12. State difference between linear and non-linear FEA analysis.
13. What is vibration FEA analysis?
14. What is shock and acceleration FEA analysis?
15. State the difference between fan, blower, pump and turbine.
16. What is deicing in automotive regulations?
17. What is CFD analysis?
18. What is the difference between compressible and incompressible analysis?
19. How to predict show wave phenomena in airbag inflators?
20. How to predict gas mass flow rate and mass fraction of gases in airbag inflators?
21. How to extract flow performance curve in pumps?
22. How to predict pressure drop and cavitations in pumps using CFD?
23. What are the optimized ways to improve the impeller design?
24. State the advantages of gerotor pump for engine lubrication?
25. How to design a gerotor pump for engine lubrication?

26. How to design a gear pump for engine lubrication?
27. Which is the best bolt layout for positive sealing of gerotor pump?
28. How to design a water pump for engine cooling?
29. How to predict the life of a steam by pass valve?
30. How to design a gear box?
31. How to animate mechanisms?
32. What is differential gear mechanism?
33. State the difference between bevel gear and spur gear?
34. State the difference between steady state and transient analysis
35. What is meant by meshing?
36. What are the equations used in CFD?
37. How to perform a FEA analysis of pump shaft twisting and bending?
38. What is the use of electronics cooling?
39. How to conduct a blood pump analysis?
40. How to manage thermal performance of biomedical systems?
41. What is the use of API standards to design valves?
42. How to predict pressure drop and flow rate in valves using CFD?
43. State the factors to be considered for structural design.
44. How to validate the design of military shelters.
45. How to perform shock, acceleration and vibration analysis for military shelters?
46. How to find deformation of pump casing due to dynamic loads?
47. How to design automotive interiors and exteriors?
48. State the quality criteria for checking a mesh?
49. How to integrate software and hardware in embedded systems?
50.How to design a Printed Circuit Boards?

Thanks for your comments.